Honda F20 Throttle Bodies Assembly Direct to Head from AT Power
Our Honda F20 45mm Throttle Body is matched to the inlet port and is available with 45mm dia trumpets or a tapered system with huge 55mm trumpets. This is a direct mounting to the cylinder head so no additional manifold is required. With the throttle butterfly very close to the inlet valve the engine response is lightening quick.
The AT Power Throttle Body incorporates a patented design matching the outright performance of a roller barrel Throttle Body while independent tests have shown >7% more airflow than a conventional butterfly Throttle Body. Mid range performance is significantly increased due the velocity of the same volume of air passing through a smaller orifice. (Click on image for details of Throttle Body Power and Torque curves)
All AT Power Throttle Bodies are made from highly attractive billet machined aluminium housings. The Throttle Body assembly includes Billet Fuel Rail, Complete Stainless Steel Linkage fully assembled to the throttles as standard, Universal TPS output shaft and a range of TPS adaptor plates. They are shipped fully assembled and ready to fit straight to the engine. The Throttle Body is factory balanced and calibrated to a set idle condition.
Note: Throttle Position Sensor Kit comprises Sensor, Adaptor Plate, and Harness Connector.
This DTH ITB system will fit F20 powered cars such as Honda S2000 and F20.
Toon telefoonnummer
Locatie: Drenthe - Emmen
Toegevoegd op 20 dagen geleden en vervalt op 4 May
Advertentie id: 472701
[ ]
251 bezoeken
